@hiro999 http://wiki.veye.cc/index.php/FFC_Cable

@xzh
你好，
这个capture的功能并不是配套triggger模式的。其功能是从流模式下当前视频流中取出一帧图像。
使用trigger模式，建议使用D_start_yuv_stream函数，注册一个回调函数。然后就会一直处于等待状态。有触发信号之后，就会收到回调函数。

@veye_xumm 好的謝謝您

@nathan-sinclair Sorry, no plans at this time.

@thn said in VEYE-MIPI-IMX385:

Is there support for legacy mode under bullseye 64 bit?

No.

@photon-94 Since you are using 327S instead of 327E，please use dtb file in VEYE-MIPI-CAM2M dir.

@veye_xumm
好的，谢谢

@veye_xumm

FIXED! thank you!

@kuo 祝贺！

@veye_xumm Perfect, thank you very much for your support. It is now working.

@tlx
VEYE-MIPI-IMX327S 不需要额外供电，如果是双板版本的327E需要额外供电。
参考: http://wiki.veye.cc/index.php/Adapter_Board_for_Raspberry_Pi/zh

@lich-mk
YES. VEYE series do not have param save function.

@vpr

Hi, please take a look at this post about the test principle of time delay.
http://forum.veye.cc/topic/22/i-want-to-synchronize-the-two-cameras-in-sync-mode/9?_=1619401819344

Our veye series modules include isp function, which involves whole frame caching in some places, so there will be a little extra delay than raw sensor's camera.

In my experience, the screen-to-screen latency test results are indeed more than 100ms.

@veye_xumm

Completely turning off denoise fixes the issue. This frame was captured on lowest default denoise levels. Thanks.

@123456
应该是由于没有给模组的poweron引脚拉高造成的。
先执行一下camera_i2c_config，然后再拍照即可。

@barbanevosa

Hi, I am not very familiar with opencv, here is the command for your reference.

http://wiki.veye.cc/index.php/V4L2_mode_for_Raspberry_Pi#Stream_to_OpenCV

Also, I think this link below will be helpful to you.
https://qengineering.eu/install-gstreamer-1.18-on-raspberry-pi-4.html

非常棒，谢谢你的无私分享~

@barbanevosa
We are very sorry that due to COVID-19, we have not been in regular office for some time recently.
A long time has passed, have you made any new progress?
According to your description, I think you should enable the lagency camera function on the bullseye system.
But it seems that the system is missing the mmal library for logging.
But strangely enough, libdmipicam.so is actually just a part of veye_raspipreview wrapped into a dynamic library, and the runtime environment requirements for both should be the same.

@nathan-sinclair
We are very sorry that due to COVID-19, we have not been in regular office for some time recently.
Based on your description, I think it is most likely due to the lack of power supply capacity of the FFC cable of the pi ZERO. Please try it with a separate 5V power supply.
Looking forward to your results.

@veye_xumm thank you very much!